|
Step 1 Connect to the security appliance console port according to the “Accessing the Command-Line
Interface” section on page 2-1. Step 2 Power off the security appliance, and then power it on. Step 3 During the startup messages, press the Escape key when prompted to enter ROMMON. Step 4 To set the security appliance to ignore the startup configuration at reload, enter the following command: rommon #1> confreg The security appliance displays the current configuration register value, and asks if you want to change the value: Current Configuration Register: 0x00000011 Configuration Summary: boot TFTP image, boot default image from Flash on netboot failure Do you wish to change this configuration? y/n [n]: Step 5 Record your current configuration register value, so you can restore it later. Step 6 At the prompt, enter Y to change the value. The security appliance prompts you for new values. Step 7 Accept the default values for all settings, except for the “disable system configuration?” value; at that prompt, enter Y. Step 8 Reload the security appliance by entering the following command: rommon #2> boot The security appliance loads a default configuration instead of the startup configuration. Step 9 Enter privileged EXEC mode by entering the following command: hostname> enable Step 10 When prompted for the password, press Return. The password is blank. Step 11 Load the startup configuration by entering the following command: hostname# copy startup-config running-config Step 12 Enter global configuration mode by entering the following command: hostname# configure terminal Step 13 Change the passwords in the configuration by entering the following commands, as necessary: hostname(config)# password password hostname(config)# enable password password hostname(config)# username name password password Step 14 Change the configuration register to load the startup configuration at the next reload by entering the following command: hostname(config)# config-register value Where value is the configuration register value you noted in Step 5. 0x1 is the default configuration register. For more information about the configuration register, see the Cisco Security Appliance Command Reference. Step 15 Save the new passwords to the startup configuration by entering the following command: hostname(config)# copy running-config startup-config １、啓動是按住“Escape” ２、出現rommon #1>時參照下面的輸入： rommon #1> confreg ３、會出現下面的文字發： Current Configuration Register: 0x00000011 Configuration Summary: boot TFTP image, boot default image from Flash on netboot failure Do you wish to change this configuration? y/n [n]: ４、當然是回答“Y”了 ５、輸“boot”引導機器 rommon #2> boot 6、機器繞開配置啓動好後，進enable,用“copy startup-config running-config”把原來的配置運行起來， 再用下面的命令把密碼改了，這次可以記牢了： hostname(config)# password password hostname(config)# enable password password hostname(config)# username name password password、 ７、改回register value，不然重啓機器配置又沒有了 hostname(config)# config-register 0x1 register value默認是0x1，願菩薩保佑你當前的機器還沒有改掉。 |