在文件中寫入一下內容 /etc/sysctl.conf:
net.ipv6.conf.all.disable_ipv6 = 1 net.ipv6.conf.default.disable_ipv6 = 1
在運行中的機器中禁用ip6
echo 1 > /proc/sys/net/ipv6/conf/all/disable_ipv6 echo 1 > /proc/sys/net/ipv6/conf/default/disable_ipv6
或者
sysctl -w net.ipv6.conf.all.disable_ipv6=1 sysctl -w net.ipv6.conf.default.disable_ipv6=1
Additional note #1: If problems with X forwarding are encountered on systems with IPv6 disabled, edit /etc/ssh/sshd_config and make either of the following changes:
(1) Change the line
#AddressFamily any
to
AddressFamily inet
(inet is ipv4 only; inet6 is ipv6 only)
or
(2) Remove the hash mark (#) in front of the line
#ListenAddress 0.0.0.0
Then restart ssh.
Additional note #2: If problems with starting postfix are encountered on systems with IPv6 disabled, either
(1) edit /etc/postfix/main.cf and comment out the localhost part of the config and use ipv4 loopback.
#inet_interfaces = localhost inet_interfaces = 127.0.0.1
or
(2) take out the ipv6 localhost from /etc/hosts .
Additional Note #3 : To disable RPCBIND ipv6 (rpcbind, rpc.mountd, prc.statd) remark out the udp6 and tcp6 lines in /etc/netconfig:
udp tpi_clts v inet udp - - tcp tpi_cots_ord v inet tcp - - #udp6 tpi_clts v inet6 udp - - #tcp6 tpi_cots_ord v inet6 tcp - - rawip tpi_raw - inet - - - local tpi_cots_ord - loopback - - - unix tpi_cots_ord - loopback - - -
