上傳並安裝SSL-***-Client到路由器

       在本實驗中，爲了使路由器支持ssl ***需要上傳並安裝SSL-***-Client到路由器。由此爲前提來模擬ssl ***的安全技術。ssl ***配置下節實驗做介紹。

 

在上傳安裝ssl-***-client之前，先搭建tftp服務器，本次試驗用的是cisco tftp server 1.1。測試路由器和tftp server的連通性

R1#ping 192.168.1.2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/17/36 ms
R1#

路由器和tftp服務器成功通信，下面我來上傳ssl-***-client

• 釋放disk0空間用作存儲上傳文件
  R1#format disk0:
  Format operation may take a while. Continue? [confirm]
  Format operation will destroy all data in "disk0:".  Continue? [confirm]
  Format: Drive communication & 1st Sector Write OK...
  Writing Monlib sectors.
  .....................................................................................................................................................
  Monlib write complete

          Format: All system sectors written. OK...

          Format: Total sectors in formatted partition: 130883
          Format: Total bytes in formatted partition: 67012096
          Format: Operation completed successfully.

          Format of disk0 comple

• 上傳ssl-***-client

      R1#copy tftp: disk0:
     Address or name of remote host []? 192.168.1.2
     Source filename []? sslclient.pkg
     Destination filename [sslclient.pkg]?
    Accessing tftp://192.168.1.2/sslclient.pkg...
    Loading sslclient.pkg from 192.168.1.2 (via FastEthernet1/0): !!!!!!!!!
    [OK - 2208871 bytes]

    2208871 bytes copied in 56.880 secs (38834 bytes/sec)

• 安裝ssl-***-client

     R1#conf t
     Enter configuration commands, one per line.  End with CNTL/Z.
     R1(config)#web*** install svc disk0:/sslclient.pkg
     SSL*** Package SSL-***-Client : installed successfully

     R1(config)#

成功上傳並安裝了ssl-***-client，這臺路由器支持ssl ***了。