NS3安裝步驟

1. NS3安裝預先設置Ubuntu環境，執行在終端以下命令
sudo apt-get install gcc g++ python

sudo apt-get install mercurial

sudo apt-get install bzr
sudo apt-get install gdb valgrind 

sudo apt-get install gsl-bin libgsl0-dev libgsl0ldbl

sudo apt-get install flex bison

sudo apt-get install g++-3.4 gcc-3.4

sudo apt-get install tcpdump

sudo apt-get install sqlite sqlite3 libsqlite3-dev

sudo apt-get install libxml2 libxml2-dev

sudo apt-get install libgtk2.0-0 libgtk2.0-dev

sudo apt-get install vtun lxc

sudo apt-get install uncrustify

sudo apt-get install doxygen graphviz imagemagick

sudo apt-get install texlive texlive-pdf texlive-latex-extra texlive-generic-extra texlive-generic-recommended

sudo apt-get install texinfo dia texlive texlive-pdf texlive-latex-extra texlive-extra-utils texlive-generic-recommended

sudo apt-get install python-pygraphviz python-kiwi python-pygoocanvas libgoocanvas-dev

sudo apt-get install libboost-signal-dev libboost-filesystem-dev

2. 安裝NS3

2.1下載NS3安裝包並解壓,官網上（www.nsnam.org）下載的3.13版本格式爲ns-allinone-3.13.tar.bz2

在終端運行以下命令進行解壓縮：

bzip2 -d ns-allinone-3.13.tar.bz2
tar xvf ns-allinone-3.13.tar

 

2.2命令終端進入解壓縮文件夾 執行命令

./build.py

2.3 進入ns-3.13目錄使用waf構建

./waf -d optimized configure
./waf -d debug configure
./waf
./waf -d debug --enable-sudo configure

3.安裝編譯啦

cd ns-allinone-3.17

./build.py

cd ns-3.17

./waf distclean

./waf configure --enable-examples --enable-tests

./waf build

4.測試一下下

./test.py

5.跑個程序看看

./waf -run examples/aodv

這樣就基本OK啦！

3. 腳本運行 進入ns-3.13目錄

./waf --run hello-simulator

會輸出如下信息: hello simulator