对于artix7系列，通常咱们使用需要使用以下电源轨：
参考文档：DS181 (v1.22) April 13, 2017 Artix-7 FPGAs Data Sheet: DC and AC Switching Characteristics
1、各电源轨及最大值
2、电压轨参考值
3、电源轨上下电顺序
The recommended power-on sequence is VCCINT, VCCBRAM, VCCAUX, and VCCO to achieve minimum current draw and ensure that the I/Os are 3-stated at power-on. The recommended power-off sequence is the reverse of the power-on sequence. If VCCINT and VCCBRAM have the same recommended voltage levels then both can be powered by the same supply and ramped simultaneously. If VCCAUX and VCCO have the same recommended voltage levels then both can be powered by the same supply and ramped simultaneously.
For VCCO voltages of 3.3V in HR I/O banks and configuration bank 0:
• The voltage difference between VCCO and VCCAUX must not exceed 2.625V for longer than TVCCO2VCCAUX for each
power-on/off cycle to maintain device reliability levels.
• The TVCCO2VCCAUX time can be allocated in any percentage between the power-on and power-off ramps.
The recommended power-on sequence to achieve minimum current draw for the GTP transceivers is VCCINT, VMGTAVCC,
VMGTAVTT OR VMGTAVCC, VCCINT, VMGTAVTT. Both VMGTAVCC and VCCINT can be ramped simultaneously. The recommended power-off sequence is the reverse of the power-on sequence to achieve minimum current draw.
If these recommended sequences are not met, current drawn from VMGTAVTT can be higher than specifications during powerup and power-down.
• When VMGTAVTT is powered before VMGTAVCC and VMGTAVTT – VMGTAVCC > 150 mV and VMGTAVCC < 0.7V, the VMGTAVTT
current draw can increase by 460 mA per transceiver during VMGTAVCC ramp up. The duration of the current draw can be
up to 0.3 x TMGTAVCC (ramp time from GND to 90% of VMGTAVCC). The reverse is true for power-down.
• When VMGTAVTT is powered before VCCINT and VMGTAVTT – VCCINT > 150 mV and VCCINT < 0.7V, the VMGTAVTT current draw can increase by 50 mA per transceiver during VCCINT ramp up. The duration of the current draw can be up to
0.3 x TVCCINT (ramp time from GND to 90% of VCCINT). The reverse is true for power-down.
There is no recommended sequence for supplies not shown.
4、关于各个电源轨的电流，数据表中提供了静态和上电电流。
如下表静态电流：
如下表 Artix7上电电流值：
工作电流根据实际情况使用功率评估软件可以获得。进一步提供电源设计的数据支撑。
进一步了解可以参考以下数据手册：
ug440-xilinx-power-estimator
ug907-vivado-power-analysis-optimization
ug997-vivado-power-analysis-optimization-tutorial